DNP Supernova Flex Guide d'installation télécharger pdf (Page 14)

Installation guide

14

dnp Supernova™ Flex Classic

How to pair motor and IR remote control

01 02 03

04 0605

Press the small white motor

programming button until the 3rd beep

is heard (about 10 seconds) to erase the

memory.

Press the small white motor

programming button until the 1st beep is

heard to switch to pairing mode.

Within 5 seconds after step 2: Press

the Middle button (stop button) on the

pairing remote control. Motor and remote

are now paired.

Check with up/down buttons if the

motor rotation direction is correct. If

the rotation direction is OK, pairing is

complete.

If the motor rotation direction needs to

change: Remove the battery cover.

Replace the battery cover.

Pairing is complete.

Press and hold the left button (P1) in the

battery compartment until the 2nd beep

is heard to reverse the rotation direction.

Check with up/down buttons that the

motor rotation direction now is correct.

(if not, redo this step).

1 2 ... 9 10 11 12 13 14 15

Commentaires sur ces manuels

Pas de commentaire